|
|
|
|
 |
 |
 |
 |
 |
 |
 |
 |
|
|
|
|
|
|
|
|
|
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
|
 |
|
 |
|
|
--CATEGORY-- General Information General Electric General Nitro HPI Savage Losi LST Sportwerks Mayhem Traxxas E. Rustler Traxxas E. Stampede Traxxas N. Rustler Traxxas N. Stampede Traxxas E-Maxx Traxxas T-Maxx Traxxas Revo --ARTICLE-- Aluminum Idler Ball Joints Battery Strap Body Posts Differential Packing Exploded Views Heat Sink Installation Kit vs. RTR Masher 2000's Metal-Gear Servos MIP CVD's Motor Gearing Motor Mount Mounting an ESC Pinion/Spur Gap Receiver Pack Receiver Strap Servo Savers/Horns Shocks Slipper Clutch Slipper Pegs Spare Screws Steel Spur Suspension Pins Top Gear Roll Pin Transmission Upgrades Wheelie Bar Wheelies Wiring Conduit |
|
|
Slipper PegsA cheap but effective improvement, is to use 12 slipper pegs in the spur gear instead of the stock 6 pegs. This will help lengthen the life of the slipper pegs, especially when using a strong modified motor.
 Another solution involves the use of steel differential balls such as these Associated Differential Balls.
 The differential ball will snap into place in the spur hole where the slipper pegs would normally go. They will even hold themselves in just as the pegs do on some spur gears such as this one offered by Kimbrough.
 From that point install the spur and replace the slipper clutch components. Adjusting the slipper clutch may seem a little different at first because you'll feel the balls spin as you tighten the slipper down. However the procedure is still the same as when you use the pegs. For more information on how to properly set the slipper clutch, see the article on adjusting the slipper clutch.
  |
|
|
|
|
|
|
|
|
 |
|
 |
|
 |
 |
 |
 |
 |
 |
 |
 |
|
|
|
|